The BOX TYPE BOCK CONDENSING UNIT automatic on-line cleaning device is a solution specially designed for the scaling of the inner tube wall of the condenser, which affects the heat exchange effect and reduces the overall efficiency of the entire unit. It can automatically clean the inner wall without disassembling the unit, reducing the The use effect and life of the condenser are artificially and effectively protected.
The operating mode and principle of the unit composition:
BOX TYPE BOCK CONDENSING UNIT is composed of a refrigeration cycle, including the host and the condenser. The main engine part includes evaporator, fan, compressor and expansion valve; the condenser is an incubator with condensing coils inside. The refrigerant absorbs the heat from the outside air in the evaporator and releases heat in the condensing coil through the heat pump cycle to heat the water in the water tank. The thermal insulation layer of the water tank is foamed with closed-cell rubber sponge or polyurethane, and has good thermal insulation performance.
The BOX TYPE BOCK CONDENSING UNIT equipment is specially equipped with a heat-absorbing medium-refrigerant. In the liquefied state, the normal temperature is lower than minus 20 degrees. Therefore, there is a temperature difference between it and the outside temperature. The refrigerant absorbs the outside temperature. The inside of the evaporator generates pressure and evaporates and vaporizes. When the refrigerant is converted from the vaporized state to the liquefied state through the work of the heat exchanger (heat pump), the objectively existing heat is released to the storage water in the water tank. Electricity is only used to release heat energy, not for direct heating, so it consumes very little electricity. When the temperature is high in summer, about 5-6 kWh of electricity is lost to produce one ton of hot water, and about 20-60 kWh is lost in cold winter weather. 25 kWh of electricity, and the annual average does not exceed 15 kWh of electricity.